程序24l01无线模块stc89c52

单片机源程序如下:

/*********************************************************************************

**********************************************************************************/

#include "reg52.h" /*包含STC单片机头文件*/

#include "QX51/qx51.h" /*包含qx51开发板头文件*/

#include "DELAY/delay.h"/*包含delay延时函数文件*/

#include "DS1602/ds1602.h" //包含1602驱动

#include "NRF/NRFreceive.h"//包涵NRF驱动

uchar buf0[5]={0,0,0,0,0}; //用于储存NRF接收地址的数组

void main()

{

qx51_init();//QX开发板初始化

init_1602();//1602初始化

nrf24l01_init(); //NRF初始化

setRX_Mode(); //设置为接收模式

SPI_Read_Buf(READ_REG+RX_ADDR_P0,buf0,TX_PLOAD_WIDTH); //读NRF的接收地址

delay_ms(100);

lcd_dis(0,0,"RX_ADDR_P0:"); //提示显示NRF接收端的地址

/************************************************/

//执行显示NRF的接收地址到1602上

lcd_dis(1,0,uchartostr(buf0[0]));

lcd_dis(1,2," ");

lcd_dis(1,3,uchartostr(buf0[1]));

lcd_dis(1,5," ");

lcd_dis(1,6,uchartostr(buf0[2]));

lcd_dis(1,8," ");

lcd_dis(1,9,uchartostr(buf0[3]));

lcd_dis(1,11," ");

lcd_dis(1,12,uchartostr(buf0[4]));

delay_ms(5000);

write_com(0x01); //清屏幕指令，将以前的显示内容清除

delay_ms(5);

/************************************************/

/************************************************/

//读NRF STATUS的值 STATUS上电复位后的值为14

lcd_dis( 0,0,"NRF-STATUS:");

lcd_dis( 0,12,uchartostr( SPI_Read(STATUS) ) );

//读NRF CONFIG的值 CONFIG在接收模式下为15 如何把 setRX_Mode() 注解掉就为上电复位值8

lcd_dis( 1,0,"NRF-CONFIG:");

lcd_dis( 1,12,uchartostr( SPI_Read(CONFIG) ) );

/************************************************/

while(1);

}