void RCC_Configuration(void)
{
    ErrorStatus HSEStartUpStatus;

    //使能外部晶振
    RCC_HSEConfig(RCC_HSE_ON);
    //等待外部晶振稳定
    HSEStartUpStatus = RCC_WaitForHSEStartUp();
    //如果外部晶振启动成功，则进行下一步操作
    if(HSEStartUpStatus==SUCCESS)
    {
        //设置HCLK（AHB时钟）=SYSCLK
        RCC_HCLKConfig(RCC_SYSCLK_Div1);

        //PCLK1(APB1) = HCLK/2
        RCC_PCLK1Config(RCC_HCLK_Div2);

        //PCLK2(APB2) = HCLK
        RCC_PCLK2Config(RCC_HCLK_Div1);
       
        //设置ADC时钟频率
        RCC_ADCCLKConfig(RCC_PCLK2_Div2);

        //FLASH时序控制
        //推荐值：SYSCLK = 0~24MHz   Latency=0
        //        SYSCLK = 24~48MHz Latency=1
        //        SYSCLK = 48~72MHz Latency=2
        FLASH_SetLatency(FLASH_Latency_2);
        //开启FLASH预取指功能
        FLASH_PrefetchBufferCmd(FLASH_PrefetchBuffer_Enable);

        //PLL设置 SYSCLK/1 * 9 = 8*1*9 = 72MHz
        RCC_PLLConfig(RCC_PLLSource_HSE_Div1, RCC_PLLMul_9);
        //启动PLL
        RCC_PLLCmd(ENABLE);
        //等待PLL稳定
        while(RCC_GetFlagStatus(RCC_FLAG_PLLRDY) == RESET);
        //系统时钟SYSCLK来自PLL输出
        RCC_SYSCLKConfig(RCC_SYSCLKSource_PLLCLK);
        //切换时钟后等待系统时钟稳定
        while(RCC_GetSYSCLKSource()!=0x08);

       
    } 关键字：STM32  RCC  配置函数